Quote:
Originally Posted by ChevyJr
If your cab is standing nose up, would you mind snapping a picture of that. I think I may have shorted one side I did the floor pan repair on. It doesn't quite reach the back wall flush. So I need to see what should happen to may add some relief cuts or cut the end off and add sheet metal in between to make it flush against the back wall.
|
Here's the picture you're looking for. You can see that the "ear" of the rear cab support closes that gap. I left a small drain hole open at the bottom of each cab corner, but that is a matter of preference.
Yesterday we were able to get the interior roof panel into primer.
This morning we hit a big local swap meet, then shot the paint.
Closeup of the "hammered" or "hammertone" finish. It's not distracting or attention grabbing, but it's still just a little different.
