The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Big Block Build is what I'm calling mine. New pics inside

earl84 · 05-06-2014, 09:39 AM

Thanks for the reply. I ask because I am in the final stages of installing a 454 in mine. Initial measurements said that the stock fan wasn't going to fit, but I was holding the radiator support in place and it was difficult at best. So I ordered up a Mark VIII fan after doing research, but I don't think that is gonna fit. So I grabbed an old fan and clutch off a 350 and it fits fine, but close. I did some searching and found measurements for a Hayden severe duty fan clutch and fan, should work fine. Gonna have to build a shroud. It is such a big deal cuz I fitted a SBC serpentine system on and had to use a long water pump to do it. I just like to make things super hard on myself on this very first attempt at doing a restomod on anything, you know. Why make it easy, ha?

05-06-2014, 09:39 AM	#135
earl84 Registered User Join Date: Aug 2011 Location: Montrose, CO Posts: 972	Re: Big Block Build is what I'm calling mine. New pics inside Thanks for the reply. I ask because I am in the final stages of installing a 454 in mine. Initial measurements said that the stock fan wasn't going to fit, but I was holding the radiator support in place and it was difficult at best. So I ordered up a Mark VIII fan after doing research, but I don't think that is gonna fit. So I grabbed an old fan and clutch off a 350 and it fits fine, but close. I did some searching and found measurements for a Hayden severe duty fan clutch and fan, should work fine. Gonna have to build a shroud. It is such a big deal cuz I fitted a SBC serpentine system on and had to use a long water pump to do it. I just like to make things super hard on myself on this very first attempt at doing a restomod on anything, you know. Why make it easy, ha?