he guys, finally an update!
I had bought a CB Performance Black Box (programmable ignition). I already had the box since december, but didnt have time to get it installed.
http://www.cbperformance.com/Product...oductCode=2013
Finally found some time this week. I had some hard time getting it to run properly. I tried installing it using the magnetic trigger schematic.
https://drive.google.com/file/d/0B4s...it?usp=sharing
but the signal wasnt good enough. I had all kinds of noise and the car wanted to stall all the time...
so I looked at the options again and saw the point_module_hall_coil_wiring option:
https://drive.google.com/file/d/0B4s...it?usp=sharing
rewired it and VOILA!...runs like a champ
here is the manual:
https://drive.google.com/file/d/0B4s...it?usp=sharing
these are the software screens:
main screen
load range screen:
timing map screen
you can program a 21x21 timing map and have a couple of special buttons in the bottom to help.
I made a excel spreadsheet to help me design a timing map. I set a couple of numbers and it fills the 21x21 table
little clip of the software running
https://www.youtube.com/watch?v=IaVhzNNnUnw
so...now to find some time to start testing and maybe go on a adyno anytime soon