Re: Project Mr. Green Jeans
Did the driver's side 2.5" lowering spindle this morning. Broke two cotter pins off that were frozen. One tapped right out with a pin punch, the other.... not so much. An hour and a half and three drill bits later... I could reassemble. Still not as bad as the passenger's side yesterday.
*(Note: Still no engine/trans in the truck, so it will come down quite a bit)*
This afternoon I cleaned/disinfected the interior a bit. I had to swap out my cleaner/water solution 6 times!!! I think I'm going to power wash the carpet *YUCK!*
Also cleaned/lubed/aligned the doors as well as put on PEX tubing on the striker pins. Both doors shut better than new!!!
__________________
- 1981 Sierra 454, NV4500 swap
- 2006 Z06, 25k miles
- 1973 Nova - Project CarNova Virus on Youtube
|