The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

75Dually · 05-25-2014, 12:22 AM

I did get all the seat frames completed today (just have 2 of them to paint tomorrow)! 3 just like the above frame (see above pic), all holes drilled, tapped, fully welded, and ground smooth. Whew it was fun, but I am glad it's done!

Kaotik79 stopped by today and picked up my old seats. Great to meet him and I hope those seats help out the cause. Glad they are out of the shop, they were taking up too much room!

Tomorrow after church I am going to drill all the mounting holes into the floor and get all the seats bolted down. Then after that (if I don't have any gremlin's to fight) I will try and work on the dash to get the bondo finished.

05-25-2014, 12:22 AM	#163
75Dually Registered User Join Date: Nov 2013 Location: Lubbock, TX Posts: 769	Re: 75 Dually build I did get all the seat frames completed today (just have 2 of them to paint tomorrow)! 3 just like the above frame (see above pic), all holes drilled, tapped, fully welded, and ground smooth. Whew it was fun, but I am glad it's done! Kaotik79 stopped by today and picked up my old seats. Great to meet him and I hope those seats help out the cause. Glad they are out of the shop, they were taking up too much room! Tomorrow after church I am going to drill all the mounting holes into the floor and get all the seats bolted down. Then after that (if I don't have any gremlin's to fight) I will try and work on the dash to get the bondo finished.