Re: PO has me PO'd
Ok, this is as much as i know on the subject.....
Looking at the pins, they have a release tang on the bottom and you can access it through the wire side, and push the pin forward. There is no way that i can see to take the pin back into the connector b/c there are to very little nubs at the top of the pin that keep it from going in the direction of the wire. The End
This is FAST's part number, but you should be able to cross referance it to a delphi part number
20140619_135952 by james_jaros, on Flickr
You can see the tang hanging down, in this pic. better, that has to be depressed to remove pin
20140619_131809 by james_jaros, on Flickr
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
Last edited by jaros44sr; 06-20-2014 at 11:47 PM.
|