Quote:
Originally Posted by dug224
Man, I sure like the look of the original seats but if you are going to long haul the truck, it may be an issue. I used seats out of a Saturn Vue that are small-ish and have removable head rests and all of the manual seat adjustments you need....I thought the drill press I got from my Dad was bulky. Pocket size compared to yours. Project looking great. dug
|
Thanks Dug, We've debated back and forth on the seats and will go the original route. We do plan to long haul and figure we can handle 5 or 6 hours in them. We did in the black truck. And if we can't, we will change them out in the future. The drill press was pretty handy for drilling all the holes for the welds.
Plug welds on the floor are done. Everything fits solid and tight. Still have to form the pieces for the outer edges of the toe board, then seam seal and coat. Going to leave the tranny hump off until we determine transmission bell housing clearance.