Once I got the floor welded in, I hammered the edge over the rocker panel to make the lip. Worked out good enough for me.
![Name: IMG_2538.jpg
Views: 977
Size: 39.6 KB](https://67-72chevytrucks.com/vboard/attachment.php?attachmentid=1286594&d=1407373944)
Found it was a lot easier to weld the underside spot welds with the cab off of the frame. Worked a lot better than when I tried to do the the front floor while sitting on the frame.
![Name: IMG_2539.jpg
Views: 1078
Size: 63.3 KB](https://67-72chevytrucks.com/vboard/attachment.php?attachmentid=1286598&d=1407374071)
Then I made some cab mount braces out of 3x1.5" tubing that I cut one side off of. Should work just as good as the original mounts it had.
![Name: IMG_2541.jpg
Views: 968
Size: 44.0 KB](https://67-72chevytrucks.com/vboard/attachment.php?attachmentid=1286600&d=1407374179)
Also, I finally got the inner cowl and lower cowl put back on the driver's side. I knew I was going to need it to mock up the front fenders.