The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

eighteenninetytwo · 08-18-2014, 02:35 PM

I took my front seat out this weekend to prep the inside for cleaning and painting etc. It turned out the bench seat was only bolted down at the front on the passenger side, and there were no corresponding holes at the rear of the seat. The passenger's side appears to have a triangular bolt pattern in the floor. I'm planning on fitting two individual low back seats so is this the correct floorpan and bolt hole pattern for a 75. IF it is NOT, what year seats fit this bolt pattern if any??

08-18-2014, 02:35 PM	#1
eighteenninetytwo Registered User Join Date: Sep 2013 Location: Redwood city, CA Posts: 691	Floorpan questions on 75 I took my front seat out this weekend to prep the inside for cleaning and painting etc. It turned out the bench seat was only bolted down at the front on the passenger side, and there were no corresponding holes at the rear of the seat. The passenger's side appears to have a triangular bolt pattern in the floor. I'm planning on fitting two individual low back seats so is this the correct floorpan and bolt hole pattern for a 75. IF it is NOT, what year seats fit this bolt pattern if any?? Attached Images Last edited by eighteenninetytwo; 08-18-2014 at 02:55 PM.