Mo progress!!
Well got a call from the body guy today and the bed is ready. I am going to look at it tomorrow morning. I also had a gap in my schedule so was able to get a few days to wire the truck. I was able to finish the rear harness to the connector for rear lights. That was a major accomplishment as I was worried about routing it in a clean way.
The return fuel line is on the drivers side so I wanted the wires to travel above that.
Here is where the wires exit the rear frame. I want the bed before I go any further with rear harness.
Here's the pig tail for reverse lights. I had to order a connector so It will wait a few more days.
The wires use all the original cab bend over clips and I tried hard to route the wires as original along the cab firewall.
I was also able to get the seats in temporarily to mark holes for the new console. While I was at it I decided to paint the top 2 tone.
I was also able to fish the courtesy light wires into the door jams. A good day it was for odds and ends.
More to come.