The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

shooter64 · 11-12-2014, 11:16 PM

I was originally going to do a parallel 4 link but decided to do a triangulated so I didn't have to mess with a watts link or panhard. I Built a cross member with a tunnel for the drive shaft out of 3/16" wall square tubing and wwelded it inside the frame rails and reinforced it with additional tubing on top of the frame rails.

11-12-2014, 11:16 PM	#1
shooter64 Registered User Join Date: Feb 2012 Location: Elyria, ohio Posts: 180	triangulated 4 link installed I was originally going to do a parallel 4 link but decided to do a triangulated so I didn't have to mess with a watts link or panhard. I Built a cross member with a tunnel for the drive shaft out of 3/16" wall square tubing and wwelded it inside the frame rails and reinforced it with additional tubing on top of the frame rails.