The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 2006 Silverado wont start? VATS? Security light flashing. Help!??!

95 S_Trucker · 12-01-2014, 12:02 PM

Hook up a battery charger. Set it to maintenance or 2 amp charge.

30-MINUTE LEARN PROCEDURE

1.Turn ON the ignition, with the engine OFF.
2.Attempt to start the engine, then release the key to ON, vehicle will not start.
3.Observe the SECURITY telltale. After approximately 10 minutes , the telltale will turn OFF.
4.Turn OFF the ignition, and wait 5 seconds .
5.Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes . The vehicle is now ready to relearn the Passlock(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.
6.Start the engine. The vehicle has now learned the Passlock(TM) Sensor Data Code and/or password.

IMPORTANT: The vehicle learns the Passlock(TM) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

7.With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.

12-01-2014, 12:02 PM	#5
95 S_Trucker Registered User Join Date: Oct 2009 Location: . Posts: 2,179	Re: 2006 Silverado wont start? VATS? Security light flashing. Help!??! Hook up a battery charger. Set it to maintenance or 2 amp charge. 30-MINUTE LEARN PROCEDURE 1.Turn ON the ignition, with the engine OFF. 2.Attempt to start the engine, then release the key to ON, vehicle will not start. 3.Observe the SECURITY telltale. After approximately 10 minutes , the telltale will turn OFF. 4.Turn OFF the ignition, and wait 5 seconds . 5.Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes . The vehicle is now ready to relearn the Passlock(TM) Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK. 6.Start the engine. The vehicle has now learned the Passlock(TM) Sensor Data Code and/or password. IMPORTANT: The vehicle learns the Passlock(TM) Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 7.With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles.