Well, I managed to screw around and found my thread on page 4 which means
I've been working on Sanity when I can but I haven't updated in awhile.
Here's a few pics just to show I haven't been a total slacker
I've been waiting to get my fuel tank painted so in the meantime I have been smoothing up the kick panels a little bit before starting on seam sealing. They're almost there. I also got the hole cut for my floor shifter.
I've also been working on rebuilding my tilt column. I am changing the upper and lower bearings and I tightened the lower column bolts with some Loctite.
I was glad I tore it down even though it felt fine and was tight because the bearings were worn and the bolts were starting to loosen. Everything is cleaned up, greased where needed, and in the process of reassembly and then paint. I've also got new tilt and turn signal levers and a new flasher switch to go on.
And last but not least, Santa sent an early Christmas present.