Quote:
Originally Posted by dwcardfan
Nice frame! I think I have seen it before.
|
Thanks Brotha, and I do believe you have...
Quote:
Originally Posted by rusty76
You getting there dude.
|
Thanx Brother!
Quote:
Originally Posted by Bomp
Front cross member slide in pretty easy? I'm using a '79. One drilled hole on each side.
Looking really good there Don.
|
Easy fit… other than getting some assistance in dragging the frame into place, this was a one man job. On mine however, I have to drill one hole on each side, elongate one hole on each side, and drill a hole to properly mount the newer Center-Link.
Quote:
Originally Posted by mjh1965
Getting it rolling is good are you going to paint it before you put the cab and bed on
|
Yessir, gotta clean and paint this frame before re-assembly begins...
Quote:
Originally Posted by Grizz1963
GREAT STANCE.....
|
Thanks Mate!!! I will post a similar pic once i trade out the rear-end… I'm aiming to have a bit of rake...
Need to remove the trailing arm set-up from the bent frame and use it to replace the
leaf spring set-up…
I've already had the GM 12 Bolt axles re-worked into the five lug set-up and the Dana rear-end on the GMC has different rear axles...
No worries just gotta grind a bunch of rivets and buy suitable Grade 8 hardware to re-install on the straight frame.