Re: Quadajet Choke "Heat Stove" Question
Not much "fiddling" involved. The procedure is explained in the shop manual, as well as in this video. It's as simple as bending the wire linkage to the correct length. Set the choke with the motor cold. Once you have bent the linkage to the correct length, step on the accelerator to engage the choke. Start the motor and allow it warm up to operating temps, (10-15 min.) Then step on the accelerator (again) to disengage the fast idle. https://www.youtube.com/watch?v=MqArPFwSa7U#t=111
__________________
Michael of the clan Hill,
"Two Seventy Two's"
71 1-ton Dually 350 4-Speed
71 C/50 Grain Truck, 350 Split-Axle 4-Speed
02 3/4 ton Express
14 Indian Chief Vintage
1952 Ford 8N, "Only Ford Allowed On The Property"
"Be American, Buy American"
|