Re: P10 SBC 350/350 install
Glad to help !
I used the stock trans cross member and the trans, a TH350, sits at the same height as stock. So, unless your looking to lay frame, it shouldn't be a problem. The trans cross member can be easily moved back, if needed. I didn't have to and will use the stock drive shaft. The idea behind the swap was to stuff in a V8 the trans with as few adaptations as possible. I thought about running an OD trans but decided to run the TH350, (I had a newly rebuilt one sitting around) re-gear the rear and throw in a posi instead, but I can see going either way.
|