Quote:
Originally Posted by texasld
How's are those CTS seats coming along? I have a set and would love to see how you mounted them!
|
I haven't mounted them yet but from looking at the drivers side centered on the steering wheel, it doesn't lOok like I will be taking advantage of the factory hole/nuts. Mine seem to be centered when sitting almost on the edge of the floor hump to the left of the outside factory mount. I will probably be drilling new holes and using a large washer or plate on the bottom side of the cab (this is basically what comes from the factory). I ran into an issue with my drivers seat. The drivers seat has a computer/curcuit board that appears to operate the seat, and I believe mine has a malfunction. I can get the passenger seat to work without any issue but the drivers seat is unresponsive. I have an impala seat that has the same track width, so I am going to see if I can swap the cts bottom and back to that track and use a less complicated seat. I am planning on recovering the seats anyway so I will get something worked out. Speaking of recovering I just got my highlander material in! It was a bit expensive ($89 yard) but I really think it will help tie the seats to the truck. No my truck is not a '72 therefore not a highlander, but since it has a ls 6.0 in it, I figure its not original therefore anything is fair game and I really like this material.