Quote:
Originally Posted by oldman3
J52, I've heard guy use the G body front end with good results. The rear of the 67-72 frame is different. Why couldn't you use the components of this system and just mount to the existing rear section of frame?...Jim
|
In this case, the rear of the frame on this truck is BEAT. Rusty, cracked and bent.
That said, I saw a thread on here (which I can't find at the moment of course
) where they installed a 67-72 rear trailing arm setup into an AD frame and it worked out pretty well - my reasoning was, since I'm already going to have to reposition the cab with the front clip anyway, and since all the stepside beds are close in design, it should not be terribly difficult.
I also have access to a 67-72 frame with bent frame horns up front, so that helped make the decision. I've taken a whole slew of measurements off my trucks and a few others I've looked at, and it seems like everything should line up nicely. How far I get, we shall see...
__________________
CURRENT
'50 GMC 100 shortbed Gen IV 4.8 LS - 4L65E (Secret truck, Shhh!!!)
Build
'63 Buick Wildcat Coupe 401ci Nailhead (Very much in pieces)
Photos
'66 Impala SS convertible 327-QJet-glide (4 speed swap one of these days...)
Photos
'69 CST/10 4x4 SWB Stepper 350 2bbl - NV4500/NP241C (Broken Truck!)
'72 Sierra Grande 2WD LWB fleetside 350-TH350
Refresh
'99 K2500 Silverado RCLB 5.7 Vortec - NV4500/NP241C (Daily)
'99 K2500 Suburban 7.4 Vortec - NV4500/NP246 (still working out the bugs)
SOLD
'71 Custom/10 2WD LWB fleetside -
'72 GMC K/3500 Dually (Sold to redryder)