Quote:
Originally Posted by Advanced Design
You will have the left side knocked out in no time.
The part above...ElCamino part?
|
You are correct, good sir. It is a 4th gen ElCamino tailgate latch assembly. Maybe if y'all are curious enough I'll post the sketch of what I'm planning
And you are correct again, because I am happy to report the left side is 90% done.
First, finished the bottom of the pillar:
Then cleared out all the old metal
Got everything lined up and marked
And then I tried a technique I saw in a build thread from one of our members in Holland, welding the rocker, mount and pan together prior to install like the factory did:
Then dropped it in, clamped the pillars down and tacked the pan in place
I still have to make the top edge of the toe-board, fit the new kick panel, and then I'll locate and weld the front pillar for the final time.
And THEN, I'll make the 7/8" long filler piece between the two new front floor pans ... Why don't they make them full width???
Anyways. A good day!
__________________
CURRENT
'50 GMC 100 shortbed Gen IV 4.8 LS - 4L65E (Secret truck, Shhh!!!)
Build
'63 Buick Wildcat Coupe 401ci Nailhead (Very much in pieces)
Photos
'66 Impala SS convertible 327-QJet-glide (4 speed swap one of these days...)
Photos
'69 CST/10 4x4 SWB Stepper 350 2bbl - NV4500/NP241C (Broken Truck!)
'72 Sierra Grande 2WD LWB fleetside 350-TH350
Refresh
'99 K2500 Silverado RCLB 5.7 Vortec - NV4500/NP241C (Daily)
'99 K2500 Suburban 7.4 Vortec - NV4500/NP246 (still working out the bugs)
SOLD
'71 Custom/10 2WD LWB fleetside -
'72 GMC K/3500 Dually (Sold to redryder)