Quote:
Originally Posted by Andy4639
Couple of things. When you flushed it did you get a good stream out as you put in, if so the core isn't stoped up. It sounds like you not circulating the coolant to me. the incoming hose should be hotter than the out hose because of the fan blowing over the coils which is pulling the heat out of the water so if both hoses feel the same then something isn't flowing right.
|
Thanks Andy. It didn't appear to have too much restriction, but I figured that if I only had a few channels open that I may still have good flow, but not enough surface area to create good heat.
The only other item I could think of would be that maybe the core is being pressurized on both sides with a wrong connection.
Here are my connections. First photo is a 5/8" hose going from the intake to the bottom of the heater core. The second photo is a 3/4" hose traveling from the top of the heater core to the water pump. Is that the correct connection on the water pump?
