[clemsonteg]

Originally Posted by Andy4639

I still say put the inlet on bottom to take care of any air pockets.

This is my old TPI motor water lines. You maybe right on the lines but I would still run the intake to bottom of heater core then top out to water pump. As I stated I have always had AC truck so I followed this drawing out of the service manual.

Thanks Andy. As mentioned previously and in the drawings, I have the intake going to the bottom of the heater core and the exit from the top of the heater core to the water pump.

Was the picture you posted in post #19 one of your motors as well? It has the hose connected with the inlet to the top and exit to the water pump.