here we go again with that fine revell detail....never seen a smooth box floor (notice them dang sink holes!) would have been easier to use a piece of corrugated styrene, but it's to thick & throws the cab/box alignment way off, so going to do it this way....plus side, enough room at the front & rear of the box for bed brace rails...
started making some kind of floor. not accurate, but cant get to fancy or the trans & t-case won't fit....
and got the frame stretched out & started knocking some of the junk off it, could'nt get rid of the mufflers though, cut them off & there goes the crossmember....