The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**TBONE1964** · 04-05-2015, 02:03 AM

Well I did some work on the K20 today. It was mostly un doing all of the gadgets that the PO installed. From what I can obviously see, the truck was set up for travel. It has everything you would need to have a large camper and pull a trailer down the highway.

There is/was aftermarket cruise, brake controller, washer pump, overflow jug and a non factory aux battery tray with an additional solenoid.

Nothing against all of these gadgets (inspector gadget would be proud), just not for me. One of my favorite parts of any vehicle is the engine compartment and I want this one to be clean and clutter free.

I took some before shots with my phone to show everything. I am thinking about replacing the drivers side inner fender because there are so many holes drilled in it

Stay tuned for some slow progress. Thanks for looking,
Tom

04-05-2015, 02:03 AM	#41
TBONE1964 Cluster King Join Date: Nov 2012 Location: Junction City, OR Posts: 5,263	Re: My new K20 Well I did some work on the K20 today. It was mostly un doing all of the gadgets that the PO installed. From what I can obviously see, the truck was set up for travel. It has everything you would need to have a large camper and pull a trailer down the highway. There is/was aftermarket cruise, brake controller, washer pump, overflow jug and a non factory aux battery tray with an additional solenoid. Nothing against all of these gadgets (inspector gadget would be proud), just not for me. One of my favorite parts of any vehicle is the engine compartment and I want this one to be clean and clutter free. I took some before shots with my phone to show everything. I am thinking about replacing the drivers side inner fender because there are so many holes drilled in it Stay tuned for some slow progress. Thanks for looking, Tom Attached Images __________________ Contact me on all of your gauge cluster needs. I specialize in restoration, repair and parts sales for 67-72 Chevy and GMC trucks. email me at tbonegarris@yahoo.com I am also a dealer for Counterpart for gauge cluster parts only. Also see my facebook page, CG&C Last edited by TBONE1964; 04-26-2015 at 09:29 PM.