The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Low68 · 04-20-2015, 01:30 AM

Swamp Rat, I asked Tom today. He said he doesn't have a website set up yet. He just does business by word of mouth mostly. He is on the board. His member page is http://67-72chevytrucks.com/vboard/member.php?u=966.

As for the door skin, I cut the skin off by grinding on the edge just enough to get through the fold of the skin. I figured since I was going to go around and gap the door anyways, it would be easier than trying to unbend the skin. On this side though, I think I am going to put a new skin on it for a couple reasons. It has a dent in the lower portion that I don't feel like trying to get out. The leading edge of the skin also curves in and bugs me. I still have the skin I pulled off and if the aftermarket one is not satisfactory, I may still put this one back on. I will have to see when I get one.

Also, for a little more info on the pulley kit, you can check out the manufacture's page here: http://www.allamericanbillet.com/pro...8&shopBy=-4682

04-20-2015, 01:30 AM	#211
Low68 Registered User Join Date: May 2001 Location: Arizona Posts: 758	Re: Avoid the Concrete Swamp Rat, I asked Tom today. He said he doesn't have a website set up yet. He just does business by word of mouth mostly. He is on the board. His member page is http://67-72chevytrucks.com/vboard/member.php?u=966. As for the door skin, I cut the skin off by grinding on the edge just enough to get through the fold of the skin. I figured since I was going to go around and gap the door anyways, it would be easier than trying to unbend the skin. On this side though, I think I am going to put a new skin on it for a couple reasons. It has a dent in the lower portion that I don't feel like trying to get out. The leading edge of the skin also curves in and bugs me. I still have the skin I pulled off and if the aftermarket one is not satisfactory, I may still put this one back on. I will have to see when I get one. Also, for a little more info on the pulley kit, you can check out the manufacture's page here: http://www.allamericanbillet.com/pro...8&shopBy=-4682 __________________ Build Thread Last edited by Low68; 04-20-2015 at 01:37 AM.