The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

In The Ten Ring · 04-24-2015, 01:05 PM

There was a fellow on the forum that suggested I flip the tool over so that the flat side (no recesses) is up. That is the side I use to get a bubble flare. I did it the same way that one would get a single flare, just on the the flat side of the jig.

Poly Armor tubing is all I have ever tried to bend or flare so I can't compare it to anything else. I am (so far) a big fan of the material.

04-24-2015, 01:05 PM	#4
In The Ten Ring Registered User Join Date: Jun 2013 Location: West Virginia Posts: 6,421	Re: Tool review: Craftsman double flare kit There was a fellow on the forum that suggested I flip the tool over so that the flat side (no recesses) is up. That is the side I use to get a bubble flare. I did it the same way that one would get a single flare, just on the the flat side of the jig. Poly Armor tubing is all I have ever tried to bend or flare so I can't compare it to anything else. I am (so far) a big fan of the material.