[splatrd]

Hi Bill. I am interested in your DIY REWIRE kit. I did an LT1 swap years ago using factory service manual and just transferred everything from donor vehicle. This go round I am swapping a '03 LQ4 6.0 from an Express van into my 72 C-10. I want to eliminate all emissions, and only use one set of O2 sensors. No A/C, but want fan control. My question is related to reprogramming the computer and wire pin outs. I found some schematics on line that seem to jive with my harness, but there are a couple of circuits that are different. Does your kit give any instructions on what pins to use? I assume that the reprogramming will change some of the pin outs? Would your kit require use of your reprogramming service to be compatible?
Thanks

Paul