Re: 1994 Suburban - bodied on custom frame
Now, the frame is custom built 1/4in 2x4 square tube and it was setup for 24/26 combo (I haven't decided on wheels at this time...). The front has uniballs with custom upper and lower control arms. The rear is a 2-link with H bar and rear lift bars (cantilever-ish). They kept as much of the stock floor as the could, and only cut our for the notch, drive shaft, and rear section of the frame. The drivetrain is stock right now.
The pics below are from their site as they were working.
1st - rails on frame table
2nd - rails again
3rd - body mounts on the rails
4th - round tube crossbars in the rear
5th - drive shaft inside
|