[GAc10boy]

So I know this issue has been beat to death on this forum but I tried to fit my Boss 338 20x8.5 with O-Ring caps (newer version) on the front of my 1.25" rotors and, exactly what everybody on this forum would expect, it needs some very minor grinding of the rotor hub. And likely some minor dimpling of the dust cap.

Not mad about it since I knew about this issue when I bought them. They actually ALMOST seat properly but not quite. Out comes the grinder!

I've also been getting in a host of parts from Summit. I'm planning to re-run my fuel system this weekend and maybe even get started on the drop. Details below on it:

- 3" Belltech drop spindles
- 1" CPP coil
- 3" CPP coil in the rear
- 2" Way2lo2 blocks
- CPP adjustable trac bar
- CPP shock relocators
- KYB shocks