Quote:
Originally Posted by sockalaminski
Overly anal much? That's within 1/8" of being dead center. It should be fine, but if you can't stand it, loosen the mount bolts and stick a crowbar between the mount and crossmember on the driver side and pry up slightly. You only need to move an 1/8". Tighten it up and your good to go.
|
I was hoping you would say that. I'm not touching it if it's fine. I'd say I'm more overly cautious because I don't know what I'm doing
The reason I even brought it up is because the engineers at Doug Thorley said the reason my header might not be fitting correctly is they noticed I had a new crate engine and that it could be miss-aligned.