|
Re: 99-00 6.0l flywheel gm# 12561757(nv4500) not available?aftermarket options?
Quote:
Originally Posted by rickcdewitt
i wish i could use a later model flywheel for the motors with the crank almost flush with the seal. but unfortunately 99-00 m/t motors have .400 more crank stickout from the rear of the block compared to the 5.3's(a/t) and later engines. i'll probably get a later engine or crank when its time to rebuild.
|
I am new to the LS crowd, but just a thought....will the ls 1 wheel fit the early long crank truck engines? It is .400 thinner than the truck wheel? There was a bit of confusion on the fit on the truck flywheel (Oriellys auto)....I told the gal, sell it to me (57 bones)....if it don't measure up, I will bring it back  Yes, I did see that the 99-00, some had the long crank....not sure where it would put your starter gear, or clutch differences, but the ls 1 flywheel is .400 thinner than the truck pc? longhorn
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|