The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

GeorgeR · 08-02-2015, 04:36 PM

I'm doing a very similar A/C install with the new Vintage Air Gen. IV system. I am running my hoses behind the fender and up through the access panel also. I had planned on using bulkheads in the removable access panel but now that I have the bulkheads and the evaporator installed, I see there is not enough room. running the hoses straight to the evap. works but I haven't figured out a good way to seal off the hoses in the access panel yet. Have you fabricated a solution to this yet? Would greatly appreciate if you could share.
Thanks,
George Rust
'49 GMC

08-02-2015, 04:36 PM	#203
GeorgeR Registered User Join Date: Feb 2015 Location: Cedar Park, TX Posts: 7	Re: Marvin (1953 3100) I'm doing a very similar A/C install with the new Vintage Air Gen. IV system. I am running my hoses behind the fender and up through the access panel also. I had planned on using bulkheads in the removable access panel but now that I have the bulkheads and the evaporator installed, I see there is not enough room. running the hoses straight to the evap. works but I haven't figured out a good way to seal off the hoses in the access panel yet. Have you fabricated a solution to this yet? Would greatly appreciate if you could share. Thanks, George Rust '49 GMC