[stick72]

Today was a milestone, a part was actually put on the Blazer, rather than being taken off (or falling off). I test fit a door. Its a reproduction door, but fits pretty well. I was hoping for a little tighter gap, its running at a 1/4 inch, but very even around the back of the door. I put a strap on the opening to put tension on it but it didn't budge, and the passenger side measures the same as the drivers side. I have read that the reproduction doors are slightly off in the hinge area, and guys have had to shim them a bit. Its possible that when I put the new bedsides on I could tighten up the gap a bit at that time.