The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

BRassi85 · 09-01-2015, 03:18 PM

I've considered swapping it to a half ton but that would still be the same question. Would the half ton A arms work on a 3/4 ton truck? If they would I would think that if I just put 3/4 ton ball joints in the A arms I would be at the same place for half the cost. I kinda like the thoughts of keeping it all 3/4 ton. All I'm planning to do for now is a coil spring drop. I just want to get it as low as possible and figured by changing out the A arms I could replace all of my bushings while I was in there.

09-01-2015, 03:18 PM	#3
BRassi85 Registered User Join Date: Aug 2015 Location: Mackinaw, Illinois Posts: 3	Re: 1969 C20 Lowering Questions I've considered swapping it to a half ton but that would still be the same question. Would the half ton A arms work on a 3/4 ton truck? If they would I would think that if I just put 3/4 ton ball joints in the A arms I would be at the same place for half the cost. I kinda like the thoughts of keeping it all 3/4 ton. All I'm planning to do for now is a coil spring drop. I just want to get it as low as possible and figured by changing out the A arms I could replace all of my bushings while I was in there.