Quote:
Originally Posted by GEARBOXGARAGE
There are several products out since, such as the Porterbuilt Inner Frame Stiffener ( http://pbfab.com/shop/inner-frame-stiffener ) that really helps to get a head start on fabricating. I wish these were available at the time I built my truck! It may seem expensive at first, but when you figure up material cost, fab and engineering time saved, it's a pretty economical piece.
|
I started a thread on the one I am building:
http://67-72chevytrucks.com/vboard/s...d.php?t=678801
I still have quite a bit to add to it. I did a SFBD on mine but if I hadn't I would really consider going with Porterbuilt. I will have less money into mine but the amount of time I put into it would make Porterbuilt's cheaper (and of course theirs is much nicer).