Re: 1959 gmc ignition, starting problem
Quote:
Originally Posted by _Ogre
it's been a while since i've set a point gap, but...
don't you set the point gap on the flat, not the lobe?
setting the points on the high side they would never close
either way; once you get it running right switch over to pertronixs points eliminator
makes those spring startups a lot easier than filing the rust off and re-gapping the points
|
Yup, I can tell you're running a Pertronix
Set the points on the high spot, then when the rubbing block gets to the flat, the points are closed. Around .016-.018" IIRC.
__________________
Old Crow
'54 Chevy Panel, '00 Bounder 36S, '95 Jeep YJ
|