[lsxponcho]

The box made its way back on the truck! This was another all day thing, It was just too late to fire up the plasma cutter so I could trim the rear cross member of the box to fit down properly...There was interference with the new rear frame cross member/tank straps, so the box is sitting a couple inches back. Other than that it fits nicely with the notch (the entire center bed support has been removed). I also cut the bed hole for the fill spout. I ran the fuel line, and ran wiring up to the front of the truck for the pump/sending unit etc. I picked up a conversion u-joint for the nv3500 yoke yesterday too, so she won't need wood blocks for much longer.