Thanks!
finally did some uploading. here are a few from the photo dump!
i worked up some oil supply for the air compressor and the IP. the p7100 has been loosely sitting in place for a while because the oil ports are a super pain in the pooper with everything mounted up.
started with this fitting in the comp case. this was a really close call getting it installed. par for the course on this turd, it was a bit of a pain.
i used the double ferrule compression fitting and SS hard tube for this as well. simple little bracket to keep from getting the shakes.
using this fancy swivel 90 npt to AN #4 fitting in the block...
i got started with the oil line.
the tee splits the oil out for the air comp and the IP.
after some enhancements i was able to use the OE dodge IP supports and made up some more line.
the line is all loomed in convoluted loom. no holes rubbed in my oil lines please!
and a crappy shot of all of the oil line in and the IP installed
