The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Removing body from frame with a two post lift

**Dirsuper** · 12-08-2015, 06:44 PM

I have my front clip and top off. Engine, tranny, transfer case out. I have a two post lift. Any wisdom on where the best place is to put the lift? I want to roll the frame out to do all cleaning/painting and to drop in new engine, tranny, transfer case, etc. While I have it in the air, my goal is to clean and paint (rattle can) the bottom of the floorboards, rear fender wells, etc. I've been out there the past few nights looking (it's up on the lift), and I can't decide where I should place the lifting pads on the body. It's a pretty solid (CA car) body. Rocker boxes seem solid.

12-08-2015, 06:44 PM	#1
Dirsuper Junior Member Join Date: Jun 2015 Location: Ramona, CA Posts: 32	Removing body from frame with a two post lift I have my front clip and top off. Engine, tranny, transfer case out. I have a two post lift. Any wisdom on where the best place is to put the lift? I want to roll the frame out to do all cleaning/painting and to drop in new engine, tranny, transfer case, etc. While I have it in the air, my goal is to clean and paint (rattle can) the bottom of the floorboards, rear fender wells, etc. I've been out there the past few nights looking (it's up on the lift), and I can't decide where I should place the lifting pads on the body. It's a pretty solid (CA car) body. Rocker boxes seem solid.