Ok so here's how the hoses look on the outside. Back when I was young and dumb I used to use braided steel on all the lines on my race car and never had any problems. So now that I am old and stupid I figured why change.
[/URL]
Here's how I have the heater supply tied into the upper housing. For now I have decided to try and pic up my water temp here as I have heard that the inlines give false readings at idle if you have the sensor in the factory location because it is so close to the exhaust port. I also made up a bracket for my coil. This came in handy as i also was able to use the bracket as a means to support the temp sensor housing. (still needs to be cleaned up and painted), but you get the idea.
[/URL]