Re: Shrunken66Stroker's build thread.
I had to modify the lower and upper radiator mounts to get the Entropy radiator in. It's a little wider than stock, more so on the bottom than top. I cut and widened the lower mounts a half inch and welded them back together. The upper mount fit pretty well and didn't need to be widened, but I did sand a little off the backs of the rubber pieces to give it more room since it was a little tight. The upper mount held the radiator out toward the engine too far so I cut a half inch out to make it vertical and give me room for the intake to turn down and miss the fans.
|