[waco]

Morning to everybody:

After 4 days of searching (2 here & 2 via google) I have not been able to find the answer to the question of how to mount the 4.3 to the '79 P10 chassis.

I have a 1979 Chevy P10 with a 292 I6 (froze solid) with a TH350 transmission & would like to replace it with a beefed up 4.3 V6, I have the complete wiring harness & computer, that I have I the back corner of the garage.

This is just going to be a weekend fishing rig, so I don't see the need to stuff my 327 into it.

From the bell housing to the rear end I see no problems, but the problem I can not find a cure for is, how do I mount the engine to the frame short of making my own mounts. Is there a bolt on solution to this problem? I am drawing a blank on this one.

Thanks for any & all responses

Andy