The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

raic65 · 02-07-2016, 01:57 PM

A few updates. Was able to roll the car out of the garage this weekend on it's own suspension. Finished welding in the upper control arm gussets, upper shock mounts, and frame boxing plates. Still need to weld in the down tubes and shock tower delete plates, but I will first fab up the transmission cross member so I can return the coyote motor to my buddy.

Hope the car is not sitting too low once the real wheels and tires are on.

02-07-2016, 01:57 PM	#13
raic65 Registered User Join Date: May 2011 Location: Bonita, Ca Posts: 156	Re: My 67 Cougar Build A few updates. Was able to roll the car out of the garage this weekend on it's own suspension. Finished welding in the upper control arm gussets, upper shock mounts, and frame boxing plates. Still need to weld in the down tubes and shock tower delete plates, but I will first fab up the transmission cross member so I can return the coyote motor to my buddy. Hope the car is not sitting too low once the real wheels and tires are on.