Today was just not my day....
Mocked up my rear end to lay out my upper tabs
Noticed that my notch didnt line up with the rearend as I measured....
Tossed on a bedside to see if my notch or if my 4 link crossmember was off
Well that sucked...I dont know where I went wrong...The only think I can think of is I measured off the wrong reference point when I was mocking up my crossmember.
So I moved the axle to see where everything should have been.
That black strip is primer so it doesnt rust.
So I proceeded to cut the crossmember out. Patched the frame and move it forward 4.5''. It was dark so I didnt get any pics. I'll be back at it tomorrow.