Quote:
Originally Posted by Gregski
No, I already went further than planned by removing the bell housing, clutch, and fly wheel
I am just going to pretend all that is just good, ha ha
|
I am planning pretty much the same job as you are doing. Mine needs a cam. It has a bad lobe. It is also one of those "no rev" RV cams. I hate those cams. So we have at the ready, a decent Crane cam (fairly tame), gear drive, a set of Edelbrock aluminum heads, Harland Sharp roller rockers, New Edelbrock intake, NOS Holley 780cfm, NOS Vintage cal custom valve covers and a host of other support parts to go with it. I want my Rat to scream
I would have done this in July or August but my back has been out since June. Just this month it has finally felt better enough to start projects on my truck again.