|
It gets to see daylight!!
It was such a nice day here today that I had to see if it could get itself out of the shop. Milk crate seat and all!! Tried the bed on and discovered I need to lower the goose neck hitch about an inch to get the bed down. Drill two new bolt holes in each side, sounds simple enough right? But in order to get the side brackets to go lower I have to do some trimming on them to clear the front bolts on the air bags, then I have to cut the exhaust pipe apart in three places and lower it where it goes over the axle and fit it all back together again, then change the length on the level control valve. Just to lower the hitch one inch....no wonder this thing is taking me so long to finish, but it was sure nice to drive it out of the shop!!
|