Quote:
Originally Posted by 99 to Life
getting there. However if it were me, I'd be bolting the whole front clip on, and getting the truck on the ground for moch up. With the running boards. See your rubber that is on the cab? that should sit on very top of your running board. Helps to have bed on too because the rear and front fender will dictate where that running board goes. So basically your RB is up too high, i know its a moch up, but don't be alarmed if that RB goes below frame. My bracket for example is close to 4" below frame if I remember right. But I mounted my body very low to frame so I didn't have to notch rear etc.
|
Thanks for the advise man. This is my first time doing this swap so it'll be a learning progress throughout.