The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Dan in Pasadena** · 04-28-2016, 05:10 PM

April 28, 2016

Picked up the new bed front panel, polished stainless bolt kit as well as rear fender bolt kit in polished stainless as well today.

My side steps appear to be drilled for the old school stainless steps with Chevy bow tie emblem and I debated whether to weld shut the holes or buy replacement steps? I bought the large flat steps the Truck Shop had to test them for fit. There is a second type of these steps with a kicked up lip but they're smaller and they were out of stock on them anyway. The blue bow tie would be painted black or red.

04-28-2016, 05:10 PM	#1263
Dan in Pasadena Senior Member Join Date: Nov 2008 Location: Glendora, CA Posts: 6,336	Re: Danny Boy is BAACK! w/ '55 Big Window April 28, 2016 Picked up the new bed front panel, polished stainless bolt kit as well as rear fender bolt kit in polished stainless as well today. My side steps appear to be drilled for the old school stainless steps with Chevy bow tie emblem and I debated whether to weld shut the holes or buy replacement steps? I bought the large flat steps the Truck Shop had to test them for fit. There is a second type of these steps with a kicked up lip but they're smaller and they were out of stock on them anyway. The blue bow tie would be painted black or red. Attached Images __________________ '55 Big Window Shortbed, Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's Dan's '55 Big Window "Build" - Well, Kinda!