[Daubs]

Set up an old laptop in the garage, so i have access to web for tech sheets, articles, how to's, etc.

Got all patch panels test fit and ready to roll. Everything test fit well, even the flare. Fired up the new HPLV gun and shot epoxy on patch panels. Of course one fell off box, but it only left some marks in the paint. Good thing all this will be hidden behind the fender flare.

Not worried.

Decided to cut in to the passenger side rear wheel arch...rust and dirt hidden in there, but not as bad as driver's side.

Got antsy and decided to pull the hitch. I did a quicky job on it last summer. Didn't strip all the paint, just knocked off the loose stuff, and hit with POR15. Then Chassis Black over top. Some areas were holding up well, other areas were rusting from underneath original paint. So busted out the aircraft stripper and had at it. Then hit with wire wheel. Tired now, going to get some dinner and relax rest of the night.