The crossmember was one of the last things holding me up before getting my cab back on and situated for hopefully the last time. It's been about time I get my exhaust going though, so I figured I better knock it out while the cab is still off.
I ordered up some essentials, some 2.5" mandrel bends and 24" glass packs. Don't really want a screamer so I'm hoping it's not gonna be too loud.
Exhaust operation in progress
Pretty basic setup. Pretty much just 90's out and runs straight back and it dumps down before the axle. I tried to keep it up and tight as best I could. I'm short one 45 and ordered some 2 inch flanges to make the crossover, but the bulk of it is there.
So that's pretty much it for right now. Nothing too exciting but important steps none the less. I'll get a couple buddies over here and get the cab back on and I'll have a whole bunch of things I can get into. Sure feels like it's coming along though, just want to keep at it and get this thing going.
Thanks for checking it out guys, catch you later.