Re: 58 Apache with C4 Flatout Engineering
Thanks Guys.
Trying to get an idea of where to set the front cross-member. Took some measurements off my other truck and set up the front fender on my engine lift. Used an old tire/rim I had that is real close to the size of tire I plan on running.
I set the fender at the stock height and put the wheel at stock location. Them lowered it down to my ride height and it looks like I need 3/4 movement to the front.
Its tricky, If you change the rake a little bit it makes the measurement different. Seems as you drop the front and raise the back it opens up the rear of the fender and changes the look. I think my 3/4 is close. I still plan on just tacking everything until I get it all together, but I'm taking a shot at getting it right the first time.
A pic of my mock-up.
|